Slight modifications necessary for Beetle and Golf
This is the final section of our modular exhausts. These cat back pipes are 2.5" 304 stainless steel, feature mandrel bends, no diameter reductions, and a single slip fit joint so no welding is required for install. Removal of the rear axle beam is not necessary to install this system.
All mounting hardware is included, and these pipes utilize the factory exhaust mounts for a perfect fit. Integrated turn down tip requires no bumper trimming.
This is a 'straight pipe', muffler-less design. Running this system with your stock exhaust makes a deep rumble without excessive noise levels, though best results will be realized by installing these pipes with our downpipe, cat, and resonator to comprise a complete system.
For use with pre-2007 vehicles only! Not for cars equipped with Diesel Particulate Filters! This converter is not CARB certified for use in California
Reviewed by: Guest03/14/2016 06:00AM
Purchased from: KERMATDI
Had my local muffler shop add a MagnaFlow Performance Muffler to it and it is almost stock sounding but with a nice low to midrange power increase.
You must login to post a review.